Rhino-mounts FM100 Manuel d'utilisateur télécharger pdf (Page 14)

100

Safety Section 1-8

FM100 02/04

SAFETY

WARNING!

Be particularly careful when transporting the Implement with the Tractor.

Turn curves or go up hills only at a low speed and using a gradual

steering angle. Rear mounted implements move the center of gravity to

the rear and remove weight from the front wheels. Make certain, by

adding front ballast, that at least 20% of the tractor’s weight is on the

front wheels to prevent rearing up, loss of steering control or Tractor tip-

over. Slow down on rough or uneven surfaces to prevent loss of

steering control which could result in property damage or possible injury.

Do not transport unless 3-Point lift lever is fully raised and in the latched

transport position. Dropping implement in transport can cause serious

damage to the tractor and/or Implement and possibly cause the operator

or others to be injured or killed. (S3PT-2)

SAFETY

DANGER!

Always disconnect the main PTO Driveline from the Tractor before

performing service on the Mower. Never work on the Mower with the

tractor PTO driveline connected and running. Blades or Drivelines could

turn without warning and cause immediate entanglement, injury or death.

(SRM-3)

WARNING!

Do not let the Blades turn when the Mower Deck is raised for any

reason, including clearance or for turning. Raising the Mower

deck exposes the Cutting Blades which creates a potentially

serious hazard and could cause serious injury or even death from

objects thrown from the Blades. (SRM-7)

DANGER!

Replace bent or broken blade with new blades. NEVER ATTEMPT TO

STRAIGHTEN OR WELD ON BLADES SINCE THIS WILL LIKELY

CRACK OR OTHERWISE DAMAGE THE BLADE WITH SUBSE-

QUENT FAILURE AND POSSIBLE SERIOUS INJURY FROM THROWN

BLADES.

(SGM-10)

DANGER!

Rotary Mowers are capable under adverse condi-

tions of throwing objects for great distances

(100 yards or more) and causing serious injury or

death. Follow safety messages carefully

-Front and Rear Deflectors, or Chain Guards, or Bands are installed

and in good, workable condition;

-Mower sections or Wings are running close to and parallel to the

ground without exposed Blades;

-Passersby are outside the existing thrown-object zone;

-All areas have been thoroughly inspected and all foreign material

such as rocks, cans, glass, and general debris has been removed.

NOTE: Where there are grass and weeds high enough to hide debris

that could be struck by the blades, the area should be: inspected

and large debris removed, mowed at an intermediate height, in-

spected closely with any remaining debris being removed, and mowed

again at desired final height. (This will also reduce power requiredto

mow, reduce wear and tear on the Mower drivetrain, spread cut

material better, eliminate streaking, and make the final cut more

uniform.) (SRM-1)

STOP MOWING IF PASSERSBY ARE WITHIN 100 YARDS UNLESS:

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Rhino-mounts FM100 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Rhino-mounts FM100