Rhino-mounts FM100 Manuel d'utilisateur télécharger pdf (Page 82)

Operation Section 4-8FM100 02/04

OPERATION

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE REMEDY

BELT SLIPPAGE Mower overloading, material too Reduce tractor ground speed but

tall or heavy maintain full PTO rpm. Cut material

twice, one high pass and then mow

at desired height. Cut a partial swath.

Oil on belts from over lubrication Be careful not to over lubricate.

Clean lubricant from belt and pulleys

with clean rag. Replace oil soaked

belts.

Belts hung up or rubbing Check belts for free travel in pulleys

and belt guides. Check under mower

and around blade spindle shafts for

wire, rags, or other foreign material.

Clean all material from under mower.

FRAYED EDGES ON COVER Belt misaligned or belt rubbing Re-align belt or guide. Be sure belt

guide. doesn't rub any other part while running.

Pulley misalignment Inspect to ensure belt is running in

center of backside idler. Shim idler

as necessary to align.

BELT ROLLOVER Pulley misalignment Re-align

Damaged belts Replace belts.*

Foreign object in pulley grooves Inspect all pulley grooves for rust,

paint or weld spots and remove.

Worn pulley groove Replace pulley

DAMAGED BELT Rollover, high shock loads or Replace belts.*

installation damage

BELT BREAKAGE High shock loads Avoid abusive mowing. Avoid hitting

the ground or large obstructions.

Belt came off drive Check drive alignment for foreign

material in grooves. Ensure proper

tension. Avoid hitting solid objects

or ground.

*Check broken belt for damage by laying it flat on floor. If belt does not lie flat (has humps or twists), which

indicated broken or stretched cords, it must be replaced.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 99 100

Pas de commentaire

Rhino-mounts FM100 Manuel d'utilisateur Page 82