Rhino-mounts TURBO 96 Manuel d'utilisateur télécharger pdf (Page 111)

ASSEMBLY

TURBO 96 01/11 Assembly Section 3-13

ASSEMBLY

HYDRAULIC OR MANUAL LIFT - PULL & OFFSET TYPE

Attach the Spring Assembly option (Figure ASM-R-0111) to the lug on the mower deck behind the Center

Gearbox. Retain using 1 x 2-3/4 bolt and locknut. Install the Hydraulic Cylinder (Figure ASM-R-0111) or the

manual Ratchet Lift Screw 1"x 2-3/4” (Figure ASM-R-0112) between the Axle Center Lug and the Lug directly

behind the Center Gearbox. Tighten all Bolts securely.

CASTER WHEEL ASSEMBLY (Semi-Mount)

Standard 4:00 x 8 caster wheel assembly

Install the two axle arm weldments (1) on the rear

axle so that the Main Beam or tube of weldment is

angled down toward ground. Space axle arm

weldment (1) so wheels will be at the desired row

spacing. Install all four bolts (3) in each axle arm

weldments and tighten bolts evenly so that space

between upper and lower clamp faces remain

approximately the same. Figure Asm-R-0303

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 201 202

Pas de commentaire

Rhino-mounts TURBO 96 Manuel d'utilisateur Page 111