Rhino-mounts TURBO 96 Manuel d'utilisateur télécharger pdf (Page 126)

OPERATION

TURBO 96 01/11 Operation Section 4-14

OPERATION

6.1 Setting Mower Height- Lift Type

1. Park the tractor and mower on level ground.

2. Using the 3-point hitch control lever, position

the front of the mower with its side skids 1” less

off the ground than desired cut height. For

example, for a 3” cut, position the skids 2” from

the ground. Set the 3-point control lever stop at

this position to maintain this height when

raising and lowering the mower.

3. Shut down the tractor and remove the key.

4. Level the mower deck front to rear by extending

or retracting the 3-point top link.

5. Level the mower side to side by manipulating

one lower lift arm length. On most tractors, at

least one of the lift arms is designed to allow for

manipulation of its length. Shortening or

extending will allow for deck leveling from side

to side.

6. Securely block up the mower at this height.

7. Remove the bolts securing the tailwheel beam

support brackets and allow the tailwheels) to

rest at ground level. Align beam and positioning

bracket holes with closest set of holes in

support brackets and reinstall securing the

beam(s) in position. Tighten all bolts and nuts.

8. Extend the tractor’s top 3-point link so that

when lifting the mower, the front of the deck will

raise 2 to 2½" before the tail wheel(s) leaves

the ground. This will allow the mower to follow

the contour of uneven terrain.

NOTE: Install optional check chains when there is a

problem with the hydraulic 3-Point lift maintaining a

set height or when a constant preadjusted cut

height is required. See Check Chains in the

Assembly Section for this accessory.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 201 202

Pas de commentaire

Rhino-mounts TURBO 96 Manuel d'utilisateur Page 126