Rhino-mounts SE4 Manuel d'utilisateur télécharger pdf (Page 117)

OPERATION

SE4 05/05 Operation Section 4-37

OPERATION

14. TROUBLESHOOTING GUIDE

Problem Possible Cause Remedy

Not Cutting Clean Blades dull. Sharpen or replace Blades.

Carrier RPM too low. Use correct PTO speed and check for

correct gearbox ratio. See specifica-

tions.

Tires mashing down grass. Reverse direction of cutting and drive

with one tractor tire out of cutter over-

lap area. Conditions to wet to cut.

Ground speed too fast. Reduce ground speed by shifting to a

lower gear.

Blades locked back. Free blades.

Blades riding up due to Blade bolt Replace blade bolts.

wear or loose bolts.

Cutter not level. See Cutting Adjustment Height.

Blades bent up. Replace Blades.

Excessive Vibrations Check Gearbox bolts. Tighten if loose.

Check for loose nuts on bladeholder Tighten if loose.

and blades.

Check for bent output shaft. If shaft Replace shaft if bent.

is bent, oil will normally leak from

bottom seal.

Check to see if blades are free Free blades so they swing.

swinging.

Check for even wear on each blade Weigh blades. Weight should be within

tip. Were both blades changed at 1 oz. Always replace both blades.

the same time.

Blade broken. Replace blades, in set.

Blade carrier bent. Replace carrier.

Blade hub not properly seated on Remove hub, check tapered spline

shaft. shaft, clean and replace.

New blade or bolts matched with Replace blades or bolts in sets.

worn blades or bolts.

Drivelines not phased correctly. Replace driveline

Implement & tractor yokes must

be in line.

Blades Wear Fast Cutting in sandy or rocky conditions Increase cutting height.

Blade Bolts Bolts not tightened. Tighten Bolts to 300 ft./lbs.

Bolt hole elongated or oversized. Replace Blade Carrier.

Locknut worn out. Replace Locknut.

Gearbox Noisy Rough gears. Run in or change Gears.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 137 138

Commentaires sur ces manuels

Pas de commentaire

Rhino-mounts SE4 Manuel d'utilisateur Page 117

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Rhino-mounts SE4