Rhino-mounts SE4 Manuel d'utilisateur télécharger pdf (Page 125)

MAINTENANCE

SE4 05/05 Maintenance Section 5-7

MAINTENANCE

STORAGE

Your rotary cutter represents an investment from which you should get the greatest possible benefit.

Therefore, when the season is over, the cutter should be thoroughly checked and prepared for storage so that

a minimum amount of work will be required to put it back into operation for the next season. The following are

suggested storage procedures:

1. Thoroughly clean the cutter.

2. Lubricate the cutter as covered in Maintenance Section.

3. Tighten all bolts and pins to the recommended torque.

4. Check the cutter for worn or damaged parts. Make replacements immediately.

5. Store the cutter in a clean, dry place with the cutter housing resting on blocks.

6. Use spray touch-up enamel where necessary to prevent rust and maintain the appearance of the

cutter.

PROPER TORQUE FOR FASTENERS

The chart lists the correct tightening torque for fasteners. When bolts are to be tightened or replaced, refer to

this chart to determine the grade of bolts and the proper torque except when specific torque values are

assigned in manual text.

RECOMMENDED TORQUE IN FOOT POUNDS UNLESS OTHERWISE STATED IN THE MANUAL*

NOTE: These values apply to fasteners as received from supplier, dry or when lubricated with normal engine

oil. They do not apply if special graphited or molydisulphide greases or other extreme pressure lubricants are

used. This applies to both UNF fine and UNC coarse threads.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 137 138

Pas de commentaire

Rhino-mounts SE4 Manuel d'utilisateur Page 125