Rhino-mounts SE4 Manuel d'utilisateur télécharger pdf (Page 118)

OPERATION

SE4 05/05 Operation Section 4-38

OPERATION

Gearbox Overheating Low on lubricant Fill to level plug

Improper type lubricant. Replace with proper lubricant.

Excessive trash build-up around Remove trash.

gearbox.

Bearing or gears set up improperly. Consult your dealer.

Streaking Conditions Conditions too wet for cutting. Allow grass to dry before cutting. Slow

Blades unable to cut that part of ground speed of tractor but keep

grass pressed down by path of engine running at full PTO rpm.

tractor tires. Cutting lower may help.

Dull Blades. Sharpen or replace blades.

Height of cutter lower at rear or See Cutting Height Instructions.

front.

Gearbox Leaking Damaged Oil Seal. Replace Seal.

Bent Shaft. Replace oil seal and shaft.

Shaft rough in oil seal area. Replace or repair shaft.

Oil seal installed wrong. Replace seal.

Oil seal not sealing in the housing. Replace seal or use a sealant on OD of

seal.

Oil level too high. Drain oil to proper level.

Sand hole in casting. Replace castings or gearbox.

Gasket damaged. Replace gasket.

Bolts loose. Tighten bolts.

Shear Pin Shears Tractor PTO not being run at Run at 540 RPM

Excessively 540 RPM

Heavy Material. Reduce ground speed. Raise cutting

height.

Not using proper pin. Replace only with recommended shear

pin.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 137 138

Pas de commentaire

Rhino-mounts SE4 Manuel d'utilisateur Page 118