Rhino-mounts BOOM ARM MOWER DB150 Manuel d'utilisateur télécharger pdf (Page 166)

MAINTENANCE

DB150 07/11 Maintenance Section 5-14

MAINTENANCE

Hardware

Most nuts and bolts will stay tight and therefore need only periodic checking. However, the following nuts and

bolts are extremely important and should receive special attention:

Spindle Housing Bolts: Tighten to 400 Ft./Lbs. Torque

Blade Bolts: Tighten to 400 Ft./Lbs. Torque

Blade Bar To Spindle Bolts: Tighten to 400 Ft./Lbs. Torque

Be certain to clamp or securely support the Spindle Housing and subassemblies to prevent

injuries to hands and feet due to inadvertent dropping or falling over.

Always wear safety glasses and gloves to prevent eye and hand injury when chiseling or

hammering on metal components. Hardened metal will chip unexpectedly.

An assembled spindle housing is quite heavy. Use a hoist or get help to handle them safely.

Lift carefully and properly using your legs to lift - NOT YOUR BACK.

Cylinder Rod Maintenance

It is important to visually inspect the hydraulic cylinder rods daily before use. It is highly recommended that

while the machine is stored or getting very little use that a protectant is applied to the hydraulic cylinder rods to

prevent degradation. If the machine receives more frequent use, be sure to fully cycle each cylinder function so

that the cylinder rod is coated by the systems hydraulic fluid. Depending on your operating environment it may

be necessary, under normal operating conditions, to apply a protective lubricant to the cylinder rods for

protection against rust and pitting. Hydraulic fluid may provide a suitable amount of protection, but remember

any protectant can attract dust and debris so attention must be given to the cylinder rods daily. Also remember

that any other protectant must be compatible with hydraulic fluid. Rhino is not responsible for rust or pitting of

the cylinder rod due to weather exposure or impacts from normal operation or mounting. If hydraulic cylinders

and or the cylinder rods are damaged as a result of the rods rusting or pitting, the hydraulic cylinders and rods

will not be covered under warranty by Rhino.

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 195 196

Pas de commentaire

Rhino-mounts BOOM ARM MOWER DB150 Manuel d'utilisateur Page 166