Rhino-mounts SE4 Manuel d'utilisateur télécharger pdf (Page 79)

ASSEMBLY

SE4 05/05 Assembly Section 3-3

ASSEMBLY

A-FRAME INSTALLATION (FIGURE AsmP-R-0017)

1. Attach “A” Frames (1) to inside of

welded hitch brackets on Mainframe,

insert Hitch Pin (12), Bushing (15), flat-

washer (11), lockwasher (14) and

install nut (13). Then attach to lug hitch

with bolt (22) and locknut (23).

2. Install the lift straps (3) on inside of

top rails on mainshield (behind gearbox

mount) and attach with 1/2" x 1-1/2"

bolts (10) and locknuts (9).

3. Insert spacer (7) between A-

frames (1). Insert 3/4" x 6" bolts (8)

thru hole in lift straps and spacer (7).

Secure with 3/4" locknut (9).

TAIL WHEEL INSTALLATION (FIGURE 5)

4. Align tailwheel beam weldment (16) between pivot brackets located behind gearbox

mount on mainshield weldment. NOTE: Long side of caster fork pivot tube is positioned

up. Attach tailwheel beam weldment to mainshield with 5/8" x 3-1/2" bolt (5) and locknut

(6).

5. Insert caster fork assembly (19) into tailwheel beam weldment (16). Install washer

(17) and secure with cotter pin (18).

6. Place tailwheel adjusting brackets on to deck and secure with bolt (20) and locknut

(21).

7. Position tailwheel beam weldment between tailwheel adjusting brackets on mainshield

weldment and secure with two 1/2" x 3" bolts (8) and locknut (9).

8. Tighten all bolts to the proper torque.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 137 138

Pas de commentaire

Rhino-mounts SE4 Manuel d'utilisateur Page 79